Thanks for adding rules for trunks, but yesterday I've created this rules:
in one trunk I use for outbound traffic
It worked fine but this morning I've found instead of them this rule:
I've changed it to my rules and again after sometimes changed in 0|NXXX.
I've changed again it to my rules and again after sometimes changed in BLANK.
PS: in Outbound I've set rule XXX.
This post has been edited 1 time(s), it was last edited by bri on 24.02.2006 at 11:39.
It looks like prefixing no longer works for me. I am using a trunk that requies any number to be prefixed with 1899. However, whatever I put in the prefix section or dial plan, it has no effect and the prefix is not being dialed.